stunthanger.com

General control line discussion => Open Forum => Topic started by: Bootlegger on December 31, 2014, 04:28:54 PM

Title: ..10-32 acorn nut
Post by: Bootlegger on December 31, 2014, 04:28:54 PM

  First of all Happy and Prosprues New Year to all aboard.

  I am looking for a few 10-32 acorn nuts for a couple of my engnes, any help will be appreciated..

Title: Re: ..10-32 acorn nut
Post by: Jim Carter on December 31, 2014, 04:35:49 PM

Howdy!  I found these listed:  http://www.amazon.com/b?node=16409871  Hope it helps!

Title: Re: ..10-32 acorn nut
Post by: john e. holliday on December 31, 2014, 05:44:51 PM

I found some acorn nuts at my local Ace Hardware store.   Had to replace the bolt in my Brodak muffler.  Acorn nut on one end of an all threaded rod and regular nylon insert nut on the other end.  Then cut off excess.

Title: Re: ..10-32 acorn nut
Post by: bill bischoff on December 31, 2014, 09:37:03 PM

Tru-Turn has several choices.

Title: Re: ..10-32 acorn nut
Post by: Bob Reeves on January 01, 2015, 07:08:14 AM

If it's a spinner nut you are wanting, I personally like the OS better than the others I have tried.

http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXCC37

Never mind, was thinking the smaller OS engines were also 10-32, not sure how 5mm converts and doubt it will fit.

Title: Re: ..10-32 acorn nut
Post by: Bootlegger on January 04, 2015, 05:45:08 PM

  Thanks fellow's  I found 'em..  Again thanks for the advice/help