Vendors Corner > Okie Air Model Products

Complete ready-to-install ball link control system

(1/1)

Motorman:
blank

Fred Underwood:
What is the bellcrank rotation each direction?  I can't tell from your description and don't know the hardware, so what is the pivot to hole distance at the elevator, and distance at the flap for pivot to elevator pushrod hole and pivot to bellcrank hole?

Sorry, I didn't notice this being posted in the vendor section when I posted.

Russell Honea:
Hi Motorman,

I spoke to Tom earlier and he told me the bellcrank drilled at 15/16 should provide about 30 degrees and at 1 inch should give you the 35 degrees you are looking for.

Russell

Navigation

[0] Message Index