stunthanger.com
Vendors Corner => LEE MACHINE SHOP => Topic started by: Dennis Toth on August 16, 2011, 06:16:02 PM
-
Jim,
I was wondering if you have or could make a prop drill that had a 1/4" pilot stud with a drill around it to allow enlarging the hole to 5mm?
Thanks, DennisT
-
Not Jim, but I have to ask: how will you drill a hole to enlarge from 1/4" to 5mm since 5mm is smaller than 1/4"?
Bill
-
Dennis
I am not set up to do drill bits.... A pilot could be cut in the end, but I'm a bit leery of that.... Those drill bits can be 'bit' hard!
Jim