I recently had my Cobra 3520 bounce off of the pavement on it's way to hiding in the weeds and it appears that the shaft has been pushed in a bit.
Having never done this on one of these motors, is there any precautions I need to take before seating it on it's front bearings and "pounding" it back into it's proper position.
I assume that you don't heat the case like it was IC.
The motor runs OK and the shaft is not bent.
Also, does anybody know where to get a 4 hole prop adapter for the 3520? I find it really strange that they use a 4 hole can and give you a 3 hole adapter. Maybe they are subtly encouraging you to use a front mount? I understand that they were originally 3 hole but...damn.
Ken