stunthanger.com

Electric Stunt => Gettin all AMP'ed up! => Topic started by: Dennis Adamisin on December 08, 2011, 07:42:34 AM

Title: New APC 12" Wide Pusher
Post by: Dennis Adamisin on December 08, 2011, 07:42:34 AM

Well APC has finally been able to get to work on the new 12" pusher.   CLP** HH%%

Reviewing: This is a wide blade drop-in replacement for the thin blade 12x6EP that would also run at the 8300-8400 RPM speed.  It was predicated by successes learned with clipped 13" props AND is also targeted for those apps running roughly 1000-1200 RPM slower than needed with a clipped 13x5.5.  APC has been devloping wide blade props for the Giant Pattern folks to replace 3-bladers.  The new prop should offer greater thrust & braking for those using the popular AXI 2826/12. 

Could not get an overlay, but attached is a side-by-side profile comparison.  Expectation is to go forward pretty quickly, should have samples by the end of the year, hopefully get some warm weather test results soon thereafter.

Whatcha think???

Title: Re: New APC 12" Wide Pusher
Post by: Dean Pappas on December 08, 2011, 07:54:57 AM

Mongo like #^

Dean

Title: Re: New APC 12" Wide Pusher
Post by: Tim Stagg on December 08, 2011, 08:14:28 AM

Put me down for 6 when they come in.

Thanks Dennis

Title: Re: New APC 12" Wide Pusher
Post by: Crist Rigotti on December 08, 2011, 10:34:35 AM

Looks good Dennis.  I'll be watching with interest.

Title: Re: New APC 12" Wide Pusher
Post by: Andrew Borgogna on December 08, 2011, 10:53:36 AM

Hey Dennis put me down for three please.
Andy

Title: Re: New APC 12" Wide Pusher
Post by: Robert Redmon on December 08, 2011, 04:33:55 PM

Thanks for the update, Dennis. Looks like a very desirable piece. I am looking forward to its debut.

Bob

Title: Re: New APC 12" Wide Pusher
Post by: Frank Imbriaco on December 08, 2011, 06:49:09 PM

Hi Dennis,
I'll take two

Title: Re: New APC 12" Wide Pusher
Post by: Rodrigo Mansano on December 09, 2011, 04:54:25 AM

Hi Dennis, I think I´m the only using the APC 13x4,5p here in Brazil, and would love to try this prop!

Thanks for the hard worK!

Rodrigo Mansano
Brazil