Hi Crist,
Well I have a couple of Align 35G ESCs (arrived yesterday) and next week I will get two Will Hubin timers setup for the Align ESCs. Looking over the programming instructions it appears that there 3 settings under "Aircraft Mode." 1. Normal Airplane, 2. Helicopter 1 and 3. Helicopter 2.
Are you running in Helicopter 2 mode?? Will Hubin is setting up his timers using an Align 35G and he says that Helicopter 1 mode does NOT appear to be a governor mode. I have not tried programming either ESC yet, so I'm fishing for information to save me possible grief. Assuming that helicopter 2 is governor mode, it is not clear (from the instructions) if you can set the ESC for hard brake when in helicopter mode. Do you know??
Crist or anyone else, Thanks for any replies to these questions.
Leester: The Align 35G is 5 volt BEC and the Align 35X is 6 volt --- I don't know about the Align 25 ESCs. Will Hubin timers need the 5 volt vs the 6 volts since the micro-controllers he uses are only rated to 5.5 volts. I think he could possibly work around a 6 volt BEC but I'm not sure.
John Cralley