All,
OK, everything in now operational, CC45 ESC set for high governor, 75 gain and default on the rest. Now the Ztron is set at 68% as a starting point. Plan is to test with a 9x5 prop to get rpm then move to an 11x5 and 12x5 and check the amps for each. My understanding is that once the ESC is set we adjust the rpm with the timer by adjusting the setting of the motor start and motor end to the same % is up or down as needed, correct? If the ground amps are above say 45 A (the A123's seem to be able to take a little higher draw rate then the LiPloy's) the prop diameter is reduced to shed load. If the motor surges (not sure what this will be like, I imagine the motor rpm hunts up and down for a bit) the ESC gain needs to be reduced, correct?
Best, Dennis