stunthanger.com

Vendors Corner => Frank Bowman Rings => Topic started by: pat king on December 07, 2009, 07:28:38 AM

Title: Ring Gap
Post by: pat king on December 07, 2009, 07:28:38 AM

What should the ring gap be for a 2 ring Enya 60 II Model 7032?

Thanks,  Pat

Title: Re: Ring Gap
Post by: Frank Bowman on February 09, 2010, 10:10:31 AM

Hello Pat, On All of my Custom fine grained Cast Iron rings I go by machinest Hand Book standards . For rings to 1" bore .001 to .0015 is best steel or chrome liner no difference. Above 1" bore or approx .70 & up .0015 to .0025. For the Enya 60 my low tension rings with a 2 ring piston will last quite a long time and an increase in power. Thanks Frank :)

Title: Re: Ring Gap
Post by: pat king on February 17, 2010, 09:00:20 PM

Frank,
Thanks for the info. I put in a set of factory rings I had in my stock of parts. When I need rings in the future I'll give you a buzz.

Pat