News:


Advertise Here

  • September 28, 2021, 11:11:49 AM

Login with username, password and session length

Author Topic: esc vs controller  (Read 386 times)

Offline Gary_Barrow

  • Trade Count: (0)
  • New Pilot
  • *
  • Posts: 7
esc vs controller
« on: June 28, 2021, 01:12:06 PM »
I fly combat and crashing is inevitable. With a timer when I crash does it turn off or does it ruin my esc or battery or timer?One guy just uses and rc receiver and the controller. Pros and cons.

Offline CircuitFlyer

  • Trade Count: (0)
  • Commander
  • ****
  • Posts: 233
    • www.circuitflyer.com
Re: esc vs controller
« Reply #1 on: June 30, 2021, 03:57:54 PM »
The KR Governor timer is the only timer that has prop strike protection.  I can confirm first hand that it works very well.  Other systems may or may not protect the motor or ESC.  Some ESCís have a max current limit but Iíve never crashed one of those so canít say how well that works. A jammed prop can cause excessive current flow that can smoke the motor windings or the ESC.  High current is not likely to damage a battery but doesnít do it any good either. Current flow wonít bother the timer at all.

Using an RC trans/receiver can be beneficial for beginners/trainers as well as scale models. Otherwise it can be a bit awkward to use and most folks end up with a timer because its just less hassle and more consistent.
Paul Emmerson
Spinning electrons in circles in Mississauga, Ontario, Canada
Low Cost DIY Control Line Timer - www.circuitflyer.com

Online Dennis Toth

  • 2020 supporter
  • Trade Count: (0)
  • Admiral
  • *
  • Posts: 3119
Re: esc vs controller
« Reply #2 on: July 08, 2021, 10:24:02 AM »
I have wondered this same thing. I had my Stuka stunt ship nose over in high, wet grass and was using the ESC current setting at normal, it tried to flip the ship over before cutting out and smoking the motor. After looking at the setting there are two current setting in the Castle Creation ESP, one on current limit and the second current cutoff type. The Current limit can be set to sensitive but that won't do it (that's were I had mine at) you have to set the Current Cutoff Type to Hard Cutoff. The cutoff type is important, if you leave it as Soft it takes a longer time to shut down the motor and can smoke in a prop stop crash. I have not tried any of the timer cutoffs but even with them I would set the ESP to sensitive and hard cutoff.

Best,    DennisT
« Last Edit: September 03, 2021, 07:02:13 AM by Dennis Toth »


Advertise Here
Tags:
 


Advertise Here