stunthanger.com
Engine basics => Engine set up tips => Topic started by: Jim Kraft on October 04, 2007, 02:01:54 PM
-
Does anyone make the teflon end pads for McCoy 40 R/H wristpins? I think these were only used on some of the later ones. I have an earlier one that has brass eyelets.
-
Scott Riese. I believe he is out of commission at the present time. Do you need some? I have a couple of extras.
Bigiron
-
I need 1 Marvin. I did a dumb thing and lapped the piston in with the pads in the pin. I use the wristpin in my fixture ( clothespin ) and lapped the end right off that little bugger. The other one is fine. Live and learn.
-
I have purchased teflon pads alone from MECOA for my K&B 61. I was just at their website and see that they list a part number for the pads alone pn: 26-4001. You might give them a try to see if what they have will adapt WWW.MECOA.COM in parts department, go to the exploded views, or you can call them directly.
Tom
-
Thanks Tom; I had forgotten about MECOA. They might have the ones for the McCoy also, as I believe they have the latest Testors McCoy engines. Thanks again for the reminder.