stunthanger.com
Engine basics => Engine set up tips => Topic started by: frank mccune on June 17, 2014, 11:02:31 AM
-
Hello Brian:
I have not received a message from you on any site. Where did you post it?
There is a site that will open my mail for a fee but I am not willing to subscribe to it.
Perhaps you could post the information on this site somewhere or a method that I may contact you via the internet or telephone.
You may contact me at zekemccune@yahoo.com.
Sincerely,
Frank McCune
-
Try sending Brian a PM (Private Message) here at Stunt Hangar. The link below will take you to his contact info. Way down at the bottom of the page, it says "Send Private Message" or something of that sort. Try that.
Sometimes ISP's or email providers get overly rambunctious about protecting folks from spam, and may be the cause of your email problem. Don't blame them...blame the spammers!
http://stunthanger.com/smf/index.php?action=profile;u=25727 (http://stunthanger.com/smf/index.php?action=profile;u=25727)
-
Hi Frank,
I replied to an email I received from you.
I think you were asking about ST46 sets.
I take a waiting list and when I have enough we run a batch. I don't take money up front. I email everyone on the waiting list when I have them ready to go out.
The set consists of ABC piston & liner, rod bushed at both ends, pin with Teflon pads at each end and there is the option for the hemi head & shims.
The last batch went out at $115AUD for the abc sets/rod/pin shipped and $25 extra for the hemi head. To Europe it $5 extra for shipping for places like Switzerland etc.
Payment method is paypal. Everything else has too much fees associated.
I have enough on the waiting list for St46 and ST60, but we are currently doing the Fox 36X that the fellas requested. When those are done the ST46 will be next.
email addy is briangardner_b1@yahoo.com.au