stunthanger.com
Engine basics => Engine set up tips => Topic started by: Rob Killick on October 18, 2006, 08:28:35 PM
-
Gentlemen ,
I purchased a ST G34 about 10 years ago (R/C version) and recently picked up 2 N/V assemblies and 2 venturies from Tower Hobbies .
My question is this:
Are there any other venturie/NV assemblies that will work better with this motor ?
Here are the venturie specs. from Tower Hobbies
NOTES FROM OUR TECH DEPARTMENT
This is the Venturi for the Supertigre G34 Control Line engine, SUPG0805.
FEATURES: Aluminum construction
INCLUDES: One venturi and O-ring
SPECS: Neck outside diameter: .47" (12mm)
Neck inside diameter: .28" (7mm)
Throat outside diameter: .58" (15mm)
Throat inside diameter: .51" (13mm)
COMMENTS: If you need the needle valve assembly order SUPG4919.
Thanks in advance f~
-
How does it work now?
Bob Z.
-
Hi Bob ,
I've never run the motor , as of yet .
The snow is starting to fly around here ...
I guess the test run(s) will have to start next spring (I don't think it will go over too well running it in the basement **)) .