stunthanger.com
Engine basics => Engine set up tips => Topic started by: Paul Taylor on February 11, 2006, 08:40:43 PM
-
Some one gave me a new ST NVA and on the bag it says for ST .51 or Fox .35.
I pulled my Fox NVA and installed the new ST NVA.
Problem:
ST NVA seems a little lose in the hole. And when I tighten the nut down I run out of threads and the NVA is not tight. Seems too long.
I put the Fox NVA back in. Last question. The Fox NVA has two holes in it. Do I point the hole up and down or point them front and back?
Thanks
Paul Taylor
-
Hi Paul; The Super Tigre spray bars generally have a brass washer with them to take up the slack for Fox 35's. As far as the Fox spray bar, the holes go front and rear so that you can't see either on when looking down in the ventura.
-
Hi Paul
It also sounds like you have a 40 size ST NVA instead of the bushing case 35 size.
There was at least 3 sizes that ST made in that NVA
You can do as the previous post said and use a washer as a shim
Randy