stunthanger.com
Engine basics => Engine set up tips => Topic started by: Bill Little on March 24, 2006, 09:41:13 PM
-
Hi Randy,
What would be your suggestions on the initial set up for a PA 51 in a 54-55 oz. USA-1?
Which header muffler would I need? I think there are two listed. (??)
Thanks
Bill <><
-
Hi Bill
A 1.25 inch rise header muffler should work fine. the ship is plenty deep in the front so I see no proble.
Billy has talked about the exact same setup
Randy
-
Bill,
While not really equivelent, the PA 40 Merlin I'm using has a header muffler I made. I had ordered one from Randy S. for it, but ended up pirating that unit for another project and had to make another one for the Cobra. The setup is really very good, though I think I went a bit shorter on the header length than Randy S. recommends. Still, a very nice run.
-
Hi Bill
(snip)
Billy has talked about the exact same setup
Randy
Thanks, Randy!
Yeah, Great Minds think alike! y1 j1 :o %^ ;D x:
-
There are more and more people using mufflers for Rear ex on not only classic planes , but modern stunters Too
I am working on 2 new RE muffler
Randy