stunthanger.com

Engine basics => Engine set up tips => Topic started by: Ken Culbertson on April 12, 2018, 03:46:10 PM

Title: OS46FX Needs Rebuild
Post by: Ken Culbertson on April 12, 2018, 03:46:10 PM

I have a OS46FX in need of new bearings and probably a connecting rod.  I have never "rebuilt" a bearing engine.  Can you do it without special tools?  If so is there someone out there that does this or would I be better served putting the $$$ towards something newer.

Thanks

Title: Re: OS46FX Needs Rebuild
Post by: M Spencer on April 13, 2018, 12:52:45 AM

Plenty of u toob bulldust on rebuilds / toonin . Cleanliness is a1 first order priority . Not outdoors in Kansas on a windy day .

Surgically clean should be adequate , and wait till the wifes out shopping before you use the oven . a pot of boiling water
usually does the trick , but then theres the dampness to take account off . So Oven Mitt and a receptical are in order .