stunthanger.com

Engine basics => Engine set up tips => Topic started by: Bootlegger on January 11, 2011, 01:33:33 PM

Title: muffler pressure
Post by: Bootlegger on January 11, 2011, 01:33:33 PM

 H^^     Fellow's where is the best spot to put a pressure tap in the muffler of a RO Jett engine, it is rear exhaust, and I'd like to try muffler pressure..
   Thanks a lot, Gil     :!

Title: Re: muffler pressure
Post by: RandySmith on January 11, 2011, 03:10:29 PM

If it is a header type muffler put it near the back of the tube
If it is an expansion chamber muffler, it will not make much differance where you put it

Randy

Title: Re: muffler pressure
Post by: Joe Mig on January 12, 2011, 04:54:46 AM

While on the subject if you don't mind .
On a tank what is the best tube to put it on the top fill or bottom overflow tube ?

Title: Re: muffler pressure
Post by: RandySmith on January 12, 2011, 08:28:46 AM

Hi Joe

I found it is best on a uniflow tube, If possible I would use a uniflow tank, If not possible I would use the bottom overflow tube

Randy

Title: Re: muffler pressure
Post by: Joe Mig on January 12, 2011, 08:54:04 AM

Hello Randy; I think I'm using a uniflow tank .
So witch is the uniflow tube ?
Thanks for the help.
Joe

Title: Re: muffler pressure
Post by: RandySmith on January 12, 2011, 10:51:14 AM

Quote from: Joe Mig on January 12, 2011, 08:54:04 AM

Hello Randy; I think I'm using a uniflow tank .
So witch is the uniflow tube ?
Thanks for the help.
Joe

The uniflow is the tube you would be filling the tank through..if it is a uniflow tank
If it just has a tube straight out of the top and a tube straight out of the bottom it maybe a standard vent tank?

Randy