stunthanger.com

Engine basics => Engine set up tips => Topic started by: Kim Mortimore on August 20, 2009, 03:07:32 PM

Title: Magnum XLS .36 and Aero Tiger .36
Post by: Kim Mortimore on August 20, 2009, 03:07:32 PM

Is the Aero Tiger a drop-in replacement for the Magnum:  case width, bolt hole pattern, distance to thrust washer?

Thanks,
Kim Mortimore
Title: Re: Magnum XLS .36 and Aero Tiger .36
Post by: Larry Wong on August 20, 2009, 03:37:54 PM
Yes Kim I did it , I use to run Magnum 36 XLS and my Aero Tiger / Thunder Tiger are the same size. y1
Title: Re: Magnum XLS .36 and Aero Tiger .36
Post by: Alan Hahn on August 21, 2009, 08:31:47 AM
I "think" the TT (or AT) projects out a bit further (to the thrust washer) than the Magnum. The person to ask would be Randy Smith for sure.
Title: Re: Magnum XLS .36 and Aero Tiger .36
Post by: RandySmith on August 21, 2009, 03:29:12 PM
Is the Aero Tiger a drop-in replacement for the Magnum:  case width, bolt hole pattern, distance to thrust washer?

Thanks,
Kim Mortimore

Kim
It is very close the Magnum is about 1 3\2 of an inch longer than the AT36

Randy