stunthanger.com
Engine basics => Engine set up tips => Topic started by: Mike Scholtes on April 02, 2017, 02:38:53 PM
-
I have a square-head Magnum 36 about 10 years old, bearings have gone bad. Did a search on here but nothing I could find is very recent. Seems to be general agreement the stock bearings are lousy. Anyone done a bearing replacement themselves, and if so how tricky is this particular engine to get apart?
Who is a good source of replacement bearings for the DIY-er?
And for Randy Smith - What would it cost to have you replace the bearings? I see years ago you were doing a lot of this due to said lousy stock bearings. A lot easier than me shopping for bearings and doing it myself.
-
I have them in stock you can call me 678 407 9376
Randy