Author Topic: Fox "burp" plug? (Read 1517 times)

Bill Little · « **on:** January 30, 2015, 03:10:30 PM »

OK, guys, don't tell me to "search", i did that.

What i want is the actual dimensions for the wooden plug for the bypass? Need the thickness the worst.

Thanks!
BIG Bear
RNMM/AMM

Jim Kraft · « **Reply #1 on:** January 30, 2015, 05:42:24 PM »

Make it about 3/8 wide and keep whittling on it to fit between the case and the sleeve. I use bass wood and form it to fit the curvature of the sleeve. Chamfer the end where it sits on the case ridge to keep the rod from hitting it. I think a Popsicle stick will work.

Bill Little · « **Reply #2 on:** January 30, 2015, 06:06:52 PM »

Quote from: Jim Kraft on January 30, 2015, 05:42:24 PM

Make it about 3/8 wide and keep whittling on it to fit between the case and the sleeve. I use bass wood and form it to fit the curvature of the sleeve. Chamfer the end where it sits on the case ridge to keep the rod from hitting it. I think a Popsicle stick will work.

Thanks a lot Bro Jim. I can go from there.

Bro Bill

Dennis Vander Kuur · « **Reply #3 on:** February 11, 2015, 01:35:56 PM »

Bill,
See picture below.
DennisV

Terry Caron · « **Reply #4 on:** February 11, 2015, 03:47:35 PM »

Bill -

I used the same diagram Dennis posted, 2 popsicle sticks were just right thickness and width, but I had to trim the length some.
Worked fine.

Terry

Author Topic: Fox "burp" plug? (Read 1517 times)

Bill Little

Fox "burp" plug?

Jim Kraft

Re: Fox "burp" plug?

Bill Little

Re: Fox "burp" plug?

Dennis Vander Kuur

Re: Fox "burp" plug?

Terry Caron

Re: Fox "burp" plug?