stunthanger.com

Engine basics => Engine set up tips => Topic started by: Paul Allen on April 21, 2008, 03:49:10 PM

Title: Enya 40 xzs
Post by: Paul Allen on April 21, 2008, 03:49:10 PM
Guy's the Enya 40 XZS
What type of run? High rev's/low pitch or 2/4.
If any one has run one in a model,would they
share some info.
Randy if your there, do you know if they have
a large taper at the top of the liner.
Thanks
Paul Allen
Title: Re: Enya 40 xzs
Post by: RandySmith on April 21, 2008, 04:04:35 PM
Guy's the Enya 40 XZS
What type of run? High rev's/low pitch or 2/4.
If any one has run one in a model,would they
share some info.
Randy if your there, do you know if they have
a large taper at the top of the liner.
Thanks
Paul Allen


HI Paul

The liner is tapered, I have not measured the taper so I don't know what you would call a large amount.
They are fit very well with what I would estimate is maybe 1.5 thou taper.  and they are fitted fairly tight.
The 40s are very well made and light motors, they put out very good power and run a strong 4 cycle

Regards
Randy