stunthanger.com

Engine basics => Engine set up tips => Topic started by: James Mills on June 09, 2010, 09:58:31 PM

Title: Enya 40-50 size
Post by: James Mills on June 09, 2010, 09:58:31 PM

Randy,

Do any of the Enyas comparable to the OS 46 fit the same beam width (between the motor mounts)?

James

Title: Re: Enya 40-50 size
Post by: RandySmith on June 10, 2010, 08:55:15 AM

Quote from: James Mills on June 09, 2010, 09:58:31 PM

Randy,

Do any of the Enyas comparable to the OS 46 fit the same beam width (between the motor mounts)?

James

Which OS 46 are you asking about?

Title: Re: Enya 40-50 size
Post by: James Mills on June 10, 2010, 05:08:33 PM

Quote from: RandySmith on June 10, 2010, 08:55:15 AM

Which OS 46 are you asking about?

Sorry, my bad.  OS LA 46.

James

Title: Re: Enya 40-50 size
Post by: Mike Scholtes on June 11, 2010, 01:24:51 PM

I have the LA40/46 (same case) and an Enya 40XZS, the new stunt motor (smaller version of the new 61CX) and can tell you the mounting holes are quite different, if that is what you are asking. The Enya 40 does swap directly with a Magnum 36, if that helps. The larger Enyas appear to swap with larger Super Tiger engines (the 61CX is interchangable with ST51 for example).

Title: Re: Enya 40-50 size
Post by: James Mills on June 11, 2010, 07:29:03 PM

Quote from: Mike Scholtes on June 11, 2010, 01:24:51 PM

I have the LA40/46 (same case) and an Enya 40XZS, the new stunt motor (smaller version of the new 61CX) and can tell you the mounting holes are quite different, if that is what you are asking. The Enya 40 does swap directly with a Magnum 36, if that helps. The larger Enyas appear to swap with larger Super Tiger engines (the 61CX is interchangable with ST51 for example).

I'm wondering if it will fit in the same bearer as far as width is concerned.

James

Title: Re: Enya 40-50 size
Post by: Leo Mehl on July 13, 2010, 09:38:51 AM

Quote from: James Mills on June 11, 2010, 07:29:03 PM

I'm wondering if it will fit in the same bearer as far as width is concerned.

James

No- the Enya is wider.You may be able to shave a little off both sides of the bearers to get it to fit. I would be coutious about shaving too much off. H^^

Title: Re: Enya 40-50 size
Post by: Damian_Sheehy on July 14, 2010, 06:36:45 PM

James,

You can find the mounting specs for all Enya Control Line engines at their web site.

Just follow this link:

http://www.enya-engine.com/DimensionCL_E.html


Damian