stunthanger.com
Engine basics => Engine set up tips => Topic started by: Allen Eshleman on August 04, 2009, 04:31:26 PM
-
I am breaking in a new Brodak 40. I put it on an old profile plane as a test stand. It starts easily. I have run it 6 times for 6 1/2 minutes.
However, the needle valve does not stay in one place. How can I tighten it?
-
There should be/have been a locking collar (nut) for the needle valve which, when installed properly, will allow the N V to be adjusted but retain the selected position by applying pressure to the spraybar into which the N V fits..........
http://www.brodak.com/shop.php?pageNum_ProductInfo=5&totalRows_ProductInfo=93&CategoryID=63
http://www.brodak.com/shop_productdetail.php?ProductID=6277
The bottom link should show a close-up view..........
Cheers,
Jim
-
Thanks Jim,
I tightened it up. It now has 15 short runs. Five or so more to go and it will fly. I have it on a very old "Cosmic Wind for break - in. The profile format made an easy test stand. I will fly it there for awhile. Then it is destined for a Nobler.