General control line discussion > Classifieds
Wanted: LA.46 Cylinder Liner/ FOUND!!!
(1/1)
Dan McEntee:
What would be the chances of finding a good, used OS LA.46 cylinder liner in some one's junk box out there. I have an experiment I want to do, and I have a usable piston, just need a decent liner. Maybe something that survived a crash, or one that got pulled for a Brian Gardner replacement? Drop me a PM if you have something out there.
Thanks a lot,
Dan McEntee
Dan McEntee:
I got what I needed, THANKS EVRYONE!
Type at you later,
Dan McEntee
Dan McEntee:
I can't tell you, but if it works, the results will be of biblical proportions! It will end the pandemic, stop world hunger, end crime in the streets, and just make the country safer for Mom, apple pie, and the girl you left behind!
Type at you later,
Dan McEntee
Dan McEntee:
That's not what I'm doing. I wouldn't waste parts from two different engines on something like that.
RandySmith:
--- Quote from: Motorman on January 28, 2021, 08:28:02 PM ---I'm doing the same thing. Putting an LA46 piston/sleeve in a Brodak 40. Not getting much power without the boost port as the side transfers are too small.
Motorman 8)
--- End quote ---
I used to do that for lots of engine, when I could not get sufficient charge into the chamber, I perforated piston ported the engine, that is mill small slots or holes in the piston side, and bring the charge from underneath the piston, let it loop around to the top of the piston and into the chamber
Randy
Navigation
[0] Message Index
Go to full version