Since you asked, here's a few tips: Stab - TE of horiz stab and LE of elevators are two piece laminations. Cut hinge pockets in them beforre gluing them together. It will be much easier than digging them out afterward. Lots of sanding will be called for here to get a nice airfoil. Nose gear install is very strong but a little hard to figure out on the plans - just visualize, it all goes togtether quite well as designed.
Wing: I used a CLC jig. It could be assembled like the Mackey Lark wing that is shown on the RSM web site under "Building Guides". I'm sure that the rod method would work also. Don't plan on using an engine that requires more than an 11" prop as the gear is too short for anything larger. That's about it, good kit, not really a tough build but like all projects, it has its challanges.