stunthanger.com
Speed,Combat,Scale,Racing => Carrier => Topic started by: Allan Perret on January 30, 2016, 09:28:11 AM
-
Need muffler [tongue or tube] Fox36 Mark 7. Case has 6-32 tapped holes, center to center spacing is 1.06". This is an engine that was moded for profile carrier, I don't know if the these mounting holes are stock configuration or not ?
-
A photo would be good.
-
A photo would be good.
-
Allan
I have a Mark V that seems to have the same dimension that I put a standard Fox muffler on. I bought the motor used , without a muffler and just used one I had, probably from a .40.
John
-
Fox made a variety of mufflers for the 6-bolt backplate 36's & 40's. There should be some out there.