stunthanger.com

Building Tips and technical articles. => Building techniques => Topic started by: roger on January 27, 2007, 09:31:34 PM

Title: sticky
Post by: roger on January 27, 2007, 09:31:34 PM

hi
my question is: when applying pin striping, or water type rondells on a wing or fuse. what dose one use to hold all that mass down? and so it wont wringle it or the striping. i notice the edges are already getting... ??? ???

roger and out.

Title: Re: sticky
Post by: Rob Killick on January 28, 2007, 11:24:08 AM

Hi Roger ,

If you're using water-slide transfers (decals) , try some Micro Set and Micro Solve to snuggle the decals down .
I use this stuff on plastic scale models .
Test it on a dopped piece of scrap balsa , using some of the clear carrier film from the decal sheet 1st .
I'm not sure if the water transfers you are using from the kit are the same formula as the plastic kit decals , so TEST , TEST , TEST !!

Good luck :)

Rob Killick