stunthanger.com

Building Tips and technical articles. => Building techniques => Topic started by: Chancey Chorney on November 13, 2016, 09:47:24 PM

Title: Sig Twister Plans
Post by: Chancey Chorney on November 13, 2016, 09:47:24 PM

Hi all again. So in case you havent read my last topic, I now need to do some repairs to my Twister in the nose area. I just realized that the engine bearers were missing and not installed while building. I bought it new used, unflown. Anyways it is looking like I will have to remove a doubler at least for a proper repair. But i was wondering if anyone here would happen to have a copy of the original plans in electronic format, or a good picture of the nose area to see if there may be anything else I should look to see if if was done while i do my repairs. Thank you.

I did get a blurry scan a while ago, but am just seeing if there is a better picture, now that I have problems....

Thank you.

Title: Re: Sig Twister Plans
Post by: Brent Williams on November 13, 2016, 10:41:16 PM

Please send your email address.

Title: Re: Sig Twister Plans
Post by: Dane Martin on November 13, 2016, 11:41:44 PM

Just in the interest of saving money, I'm sending Chancey some stuff in the mail. I can include an original print off the plans

Title: Re: Sig Twister Plans
Post by: Chancey Chorney on November 16, 2016, 09:29:09 PM

I guess we can now close this thread. I have a pdf of the Fancher Twister and now a low resolution copy of the original. Thanks for the help.