Building Tips and technical articles. > ARF'S
blank
Motorman:
blank
Steve Nelson:
Mine was poorly aligned and most of the glue pooled to one corner. I applied some warm air from a heat gun snd using light pressure with my finger, was able to lift it off. Now looking for a good solvent to soften whatever glue they used and clean up the csnopy before re-ataching again.
fred cesquim:
Most likely rc56 glue . water softens and you can clean up . Leave a wet rag in cotact for some time and will soften.
Have used this to glue RC arfs canopies for ages
Howard Rush:
Make sure the canopy gets put back on right. I see lots of stunt planes with the canopy on backwards.
Dennis Nunes:
--- Quote from: Howard Rush on February 28, 2021, 05:40:34 PM ---Make sure the canopy gets put back on right. I see lots of stunt planes with the canopy on backwards.
--- End quote ---
Hey Howard, is this one of them? LL~
Dennis
Navigation
[0] Message Index
[#] Next page
Go to full version