Author Topic: Incidence Settings - Nobler ARF (Read 1379 times)

Frank Imbriaco · « **on:** March 02, 2011, 03:30:40 PM »

Gents,
Anyone know the stock incidence settings for the stab & wing?
I've been told that the Nobler ARF is similar to the 57 ??
Otherwise, I'm going with zero-zero .
That , along with 2-3 degrees right offset on the engine.
Thanks

Bootlegger · « **Reply #1 on:** March 02, 2011, 03:52:47 PM »

Frank, if memory serves I set my arf at 0-0 and put a .010 shim under the front of the motor to put just a small amount of down thrust in the engine.
As for side thrust just enough to know that it doesn't have any "in" thrust.

Oh, I also installed adj lead out's.
Hope that this helps...

john e. holliday · « **Reply #2 on:** March 03, 2011, 09:09:07 AM »

Stay with zero settings on the ARF Nobler. I had to do some cutting to get the wing to match the stab and engine mounts. And a little offset of engine to outside of circle does not hurt as long as it is not excessive.

Garf · « **Reply #3 on:** June 27, 2011, 12:33:43 PM »

I had to use thrust wedges to get downthrust in the engine from my first NoblARF.

Neal Beekman · « **Reply #4 on:** June 28, 2011, 05:50:00 PM »

My ARF profile Nobler.

Author Topic: Incidence Settings - Nobler ARF (Read 1379 times)

Frank Imbriaco

Incidence Settings - Nobler ARF

Bootlegger

Re: Incidence Settings - Nobler ARF

john e. holliday

Re: Incidence Settings - Nobler ARF

Garf

Re: Incidence Settings - Nobler ARF

Neal Beekman

Re: Incidence Settings - Nobler ARF