Author Topic: Brodak Baby Clown Engine Mounting (Read 1435 times)

Dan Labine · « **on:** April 18, 2007, 05:38:11 PM »

I am just starting to put together this ARF. I am using an OS 25LA. When I put the motor onto the mounts and if I drill the holes for the engine bolts I will have less than 1/16th of an inch of meat left on the wood. This does not seem right. How can I improve on this situation? Is this the right motor plane combination? Should I use an engine with a wider case?

John Paris · « **Reply #1 on:** April 18, 2007, 06:50:54 PM »

Dan,
The width is set up more for a Fox 35, but I have installed an FP 20 without issue (same bolt pattern). Make sure that you have it centered as best you can. Additionally, to make it fit the nose a little better, I cut out about 1/4-3/8 inch back from the standard cut out. That would also help a bit for balance.
Good Luck,
John

Larry Renger · « **Reply #2 on:** April 18, 2007, 07:01:06 PM »

One can but hope you are talking about the Super Clown, not the Baby! The Baby is a 136 sq.in. 1/2A model.

Roger Vizioli · « **Reply #3 on:** April 18, 2007, 07:18:03 PM »

Super Clown is a "little" wide between mounts, depending on your choice of engine.
3/32" aircraft ply shim, epoxied on each mount closes the gap and a Brodak .25 fits nicely.
You could still do this to strengthen your mounting.
Roger

Dan Labine · « **Reply #4 on:** April 19, 2007, 10:35:24 AM »

I should have said "Super Clown" not baby Clown. I was thinking of using the Brodak Aluminum engine mounting system part #BH-795. This may solve the problem. I wil look at moving the engine back as well.

Author Topic: Brodak Baby Clown Engine Mounting (Read 1435 times)

Dan Labine

Brodak Baby Clown Engine Mounting

John Paris

Re: Brodak Baby Clown Engine Mounting

Larry Renger

Re: Brodak Baby Clown Engine Mounting

Roger Vizioli

Re: Brodak Baby Clown Engine Mounting

Dan Labine

Re: Brodak Baby Clown Engine Mounting