I gave it a few days and then pulled the wreckage out and evaluated it for repair. Not as bad as I 1st thought. Wing needs a couple center ribs / spar splices + sheeting, it broke at the fuse sides -1 side top, other side bottom.
Fuse broke at the wing trailing edge, transition from ply to balsa at this point + previous repair = stress point. The front end was crunched, but I pulled it back into shape and CA'd together.
Added some 1/16th cross grain above the crutch beams, this will allow me to reinstall the original filler block with reinforcement. Repaired the front of the beams where they split out at the bolt holes with JB Weld. A metal backing plate on the oppisite side from the engine should restore most of original strength.
The repair at wing TE was started with CyA the sheeting and formers back into place. Added a pair of 1/4" balsa longerons to bridge the seam, and a couple smaller ones up top to support the sheeting repair that is spliced in. Looking pretty fair so far - I think it will be worth while, and I needed something to do while I watched the Magic pull off a win against the Lakers!