This is a Baby Clown ARF I just completed.  The engine is a customized Space Hopper.  Killer Bee crankshaft, Tee Dee top end, Norvel head and color by Wiltze!

Hinges are the lightest Spiderwire sewn in a figure eight pattern with 3/32" spacing between stitches.  The tank is simply glued on with Goop adhesive. 

My only complaint on the model design is the extreme length of the landing gear.  Since the original had no gear, the new ones could be at least 3/4" shorter.  Construction is clean and solid, weight is 6.6 ounces, a very reasonable number (my old, hand built one was 5 ounces, but used a MUCH less powerful engine)

The checkerboard is trim Moneykote red/clear check, the AMA 9246 is trim Moneykote.  Stickers applied with Windex as a cleaner/slither coat.

Larry, take a deep breath and slow down!  LOL!!  You have had too many engine problems here lately.......... Smoothie and now the BC.  Don't get in too big a rush!

I finally got a flight in on the BC.  It has a lot of potential.  I plan to go to a backplate pressure tap to even out the run.  Also there is a mild wing warp that should be easily cured.  First flight was on 42.5' .008 lines with a Medallion .049 running the C*x black 6x3 prop (new version).  Even with the engine running a bit rich, it did a wingover quite nicely.

3/4 oz tank by Perfect, possibly now produced by Brodak.