stunthanger.com

Vendors Corner => Aero Products => Topic started by: kenny stevens on September 26, 2013, 05:33:11 PM

Title: coppier stretch
Post by: kenny stevens on September 26, 2013, 05:33:11 PM

Hi Randy  Just had SV-22 plans copied at FED EX store and the plans were stretched 1/4 inch ..   They tried some things that did not work.  I need the nose and tail moment for SV-22 as this may have been happening for years but I usually check. Kenny

Title: Re: coppier stretch
Post by: RandySmith on September 26, 2013, 11:57:41 PM

Quote from: kenny stevens on September 26, 2013, 05:33:11 PM

Hi Randy  Just had SV-22 plans copied at FED EX store and the plans were stretched 1/4 inch ..   They tried some things that did not work.  I need the nose and tail moment for SV-22 as this may have been happening for years but I usually check. Kenny

Hi  Kenny

The tail is  17.5 inches , nose  is 10.3 inches

Randy

Title: Re: coppier stretch
Post by: kenny stevens on September 27, 2013, 07:49:21 AM

Thanks Randy

Title: Re: coppier stretch
Post by: Paul Taylor on December 24, 2013, 05:34:01 PM

So for those of us who are still learning.

That is nose ring to flap hinge and flap hinge to elevator hinge line?

Title: Re: coppier stretch
Post by: Dick Pacini on December 25, 2013, 02:31:19 AM

Quote from: Paul Taylor on December 24, 2013, 05:34:01 PM

So for those of us who are still learning.

That is nose ring to flap hinge and flap hinge to elevator hinge line?

I believe it is the nose ring to the leading edge and the flap hinge to the elevator hinge.

Title: Re: coppier stretch
Post by: Paul Taylor on December 25, 2013, 07:31:53 AM

Thanks.
Still learning.  H^^