stunthanger.com
Building Tips and technical articles. => 1/2 A building. => Topic started by: Robert McHam on August 13, 2009, 10:30:07 PM
-
To be real I am talking about the 1" and 1 1/8" for Cox engines. Nothing larger.
Also are these old stock or does MECOA actually produce any of these?
There seems to be a real shortage of spinners for engines up to say, .074 CID but these seem nice for the price.
Robert
-
Robert,
I've used a couple of 1 3/8" spinners for a 1/2A project. I had to trim the cutouts a bit to fit the props.
My only complaint was that the 5-40 screw on one of the spinner sets stripped when I tightened it. I probably tightened it a little too much.
I suspect that they are all old stock, but they seem to work fine for the application. I tried to order a couple of spinners off the web a while back and waited weeks and they were never shipped. My order could have just slipped through the cracks, but I was able to get them when I was at one of the MECOA swap meets. Which, by the way there is a MECOA swap meet tomorrow (8/15) that I'm planning to attend.
PM me if you would like me to try to get a couple spinners when I'm there.
Regards,
Stan