stunthanger.com
Building Tips and technical articles. => 1/2 A building. => Topic started by: Chancey Chorney on May 19, 2016, 07:39:38 PM
-
Hi there. Well, it is not exactly a 1/2a plane, but rather a 1/2a handle I had recently made. Nothing fancy, just something I wanted to try out. It is nothing more than a 1/8" plywood center with 1/4" balsa sides sanded to contour and finished with Minwax Polyurethane. Just thought I would share.
-
Picture 2.
-
Looks light, what kind of line spacing does it have?
-
Nice little fingertipper.
-
Lookin sweet Chancey!
-
Thank you for the compliments on my little handle. The spacing was just measured at 4 1/4". I would like to sy that it was traced off of a handle that was included in a 1/2a control line kit I acquired recently. The only thing is that the included handle was made of plastic, and I believe made by Merco?
-
4" spacing? Better have at least a 3" bellcrank or incredibly steady hands and good reactions. My 1/2 A handles run around 2" spacing.
Really pretty job, though.